Blend quality indicator and rear wheel.

I still hope that this summer I will go again to travel far and for a long time, so the weekend has to be spent mainly on preparing a motorcycle.

Over the weekend, completed the first relatively large task - changed the rear tires. For some, this is a matter of one hour, but I have never had to change tires on a Honda. Moreover, since the purchase of a motorcycle I drove on an old tire more than 30 thousand kilometers, it has also been produced in 2005. The basic idea, as always, is simple: do the work yourself, so that in case of a puncture or other problems on the road, you can imagine what to do. Although, I doubt that alone I will change the camera in the field.
A huge stick with a hammered bar helped to remove the rubber from the rim - it served as a lever. I disassembled without problems, but I could not immediately put the wheel on. And not because he could not pull it on the rim, and then that it did not sit down after inflating. At first I remembered about the lubrication of the sides with soapy water, but this did not help.Only when he pumped up the wheel to 3.5, the atmospheres tire with cotton sat, as is the case with car wheels at tire service.
1. Rubber buffers. Two pairs of whole, the other between them broke.

2. Diagnosed the pads. Judging by the photos of new sets on the Internet, these are not so bad yet, so I left it.

3. The bearings are closed, there are no backlashes, nothing crunches - they didn’t touch them either.

4. Just rolling out yesterday realized the difference between fresh and oak wood tires a decade ago. I got a rear brake! I never thought that they can be so effectively slow down.

5. I also tested this thing on Tula:

6. It is called the "Quality indicator for the mixture IKS-1". It is a transparent candle with 5 cm glass inside and an electrode at the side.

7. A special cap is put on the candle to which the high-voltage wire is connected.

8. Thus, this simple device allows you to look straight "into the engine." Or rather, the color of the flame burning mixture.

9. The color of the flame should be bright blue. If it is orange, then the mixture is rich. Normally, I still could not adjust the engine, but the toy is entertaining. I bought it two years ago on Avito for 300 rubles.

ten.If anyone is interested - photo instructions. 89 year!

11.

12.

Related news

Blend quality indicator and rear wheel image, picture, imagery


Blend quality indicator and rear wheel 26


Blend quality indicator and rear wheel 74


Blend quality indicator and rear wheel 84


Blend quality indicator and rear wheel 82


Blend quality indicator and rear wheel 87


Blend quality indicator and rear wheel 33


Blend quality indicator and rear wheel 18


Blend quality indicator and rear wheel 31


Blend quality indicator and rear wheel 79


Blend quality indicator and rear wheel 1